Re: Bah! How do I change channels?
On Fri, Jun 26, 2009 at 9:42 AM, Devin
> On Fri, Jun 26, 2009 at 7:50 AM, Andy Walls<awalls@xxxxxxxxx> wrote:
>> I use either v4l2-ctl or ivtv-tune
>> $ ivtv-tune -d /dev/video0 -t us-bcast -c 3
>> /dev/video0: 61.250 MHz
>> $ v4l2-ctl -d /dev/video0 -f 61.250
>> Frequency set to 980 (61.250000 MHz)
> Hello Andy,
> I had sent George some email off-list with basically the same
> commands. I think what might be happening here is the tuner gets
> powered down when not in use, so I think it might be powered down
> between the v4l-ctl command and the running of the other application.
> I have sent him a series of commands to try where he modprobes the
> xc3028 driver with "no_poweroff=1", and we will see if that starts
> Devin J. Heitmueller - Kernel Labs
> video4linux-list mailing list
> Unsubscribe mailto:video4linux-list-request@xxxxxxxxxx?subject=unsubscribe
I had ran into this before with the KWorld a few months back.
However, whatever problem existed that forced me to add
"no_poweroff=1" to modprobe.conf for the em28xx module has went away.
I have been able to use v4l-ctl or ivtv-tune without any problems to
tune analog channels over cable.
Senior Software Engineer
101 East Carmel Dr. Suite 105
Carmel, IN 46032
(317)566-1677 Ext. 206
video4linux-list mailing list