Re: [Samba] Lots of failed message in smbd.log: NT_STATUS_OBJECT_NAME_NOT_FOUND
- Date: Thu, 7 Jun 2018 11:17:22 +0100
- From: Rowland Penny via samba <samba@xxxxxxxxxxxxxxx>
- Subject: Re: [Samba] Lots of failed message in smbd.log: NT_STATUS_OBJECT_NAME_NOT_FOUND
On Thu, 7 Jun 2018 09:59:13 +0000
"Georg.Biberger--- via samba" <samba@xxxxxxxxxxxxxxx> wrote:
> Attached smb.conf now inline:
> security = ADS
> workgroup = MUC
> realm = europe.bmw.corp
> netbios name = eda
> netbios aliases = lpeda1 lpeda1.muc
> log file = /lfs/EDA/DATA/SOFTWARE/samba/var/log/samba/%m.log
> log level = 2
> # Default ID mapping configuration for local BUILTIN accounts
> # and groups on a domain member. The default (*) domain:
> # - must not overlap with any domain ID mapping configuration!
> # - must use a read-write-enabled back end, such as tdb.
> # - Adding just this is not enough
> # - You must set a DOMAIN backend configuration, see below
> idmap config * : backend = tdb
> idmap config * : range = 79846-500000000
Did you read the commented (#) lines above ?
If you did, did you understand the last one:
'You must set a DOMAIN backend configuration, see below'
It looks like you want to use the winbind 'rid' backend, so I would
expect lines similar to these:
idmap config * : backend = tdb
idmap config * : range = 3999-7999
idmap config MUC : backend = rid
idmap config MUC : range = 79846-500000000
To unsubscribe from this list go to the following URL and read the