Web lists-archives.com

Re: [PATCH] net: dsa: mv88e6xxx: avoid error message on remove from VLAN 0





31.05.2019 17:37, Andrew Lunn wrote:
>> I'm not sure that I like the semantic of it, because the driver can actually
>> support VID 0 per-se, only the kernel does not use VLAN 0. Thus I would avoid
>> calling the port_vlan_del() ops for VID 0, directly into the upper DSA layer.
>>
>> Florian, Andrew, wouldn't the following patch be more adequate?
>>
>>     diff --git a/net/dsa/slave.c b/net/dsa/slave.c
>>     index 1e2ae9d59b88..80f228258a92 100644
>>     --- a/net/dsa/slave.c
>>     +++ b/net/dsa/slave.c
>>     @@ -1063,6 +1063,10 @@ static int dsa_slave_vlan_rx_kill_vid(struct net_device *dev, __be16 proto,
>>             struct bridge_vlan_info info;
>>             int ret;
>>      
>>     +       /* VID 0 has a special meaning and is never programmed in hardware */
>>     +       if (!vid)
>>     +               return 0;
>>     +
>>             /* Check for a possible bridge VLAN entry now since there is no
>>              * need to emulate the switchdev prepare + commit phase.
>>              */
>  
> Hi Vivien
> 
> If we put this in rx_kill_vid, we should probably have something
> similar in rx_add_vid, just in case the kernel does start using VID 0.

Kernel currently does, but it is caught in
mv88e6xxx_port_check_hw_vlan() and returns -ENOTSUPP from there.