Re: [PATCH 1/3] dt-bindings: pwm: kona: Add new compatible for new version pwm-kona
- Date: Fri, 11 Jan 2019 13:28:45 -0800
- From: Scott Branden <scott.branden@xxxxxxxxxxxx>
- Subject: Re: [PATCH 1/3] dt-bindings: pwm: kona: Add new compatible for new version pwm-kona
On 2019-01-11 12:48 p.m., Uwe Kleine-König wrote:
On Fri, Jan 11, 2019 at 10:51:14AM +0530, Sheetal Tigadoli wrote:
From: Praveen Kumar B <praveen.b@xxxxxxxxxxxx>
Add new compatible string for new version of pwm-kona
Signed-off-by: Praveen Kumar B <praveen.b@xxxxxxxxxxxx>
Reviewed-by: Ray Jui <ray.jui@xxxxxxxxxxxx>
Reviewed-by: Scott Branden <scott.branden@xxxxxxxxxxxx>
Signed-off-by: Sheetal Tigadoli <sheetal.tigadoli@xxxxxxxxxxxx>
Documentation/devicetree/bindings/pwm/brcm,kona-pwm.txt | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/pwm/brcm,kona-pwm.txt b/Documentation/devicetree/bindings/pwm/brcm,kona-pwm.txt
index 8eae9fe..d37f697 100644
@@ -3,7 +3,7 @@ Broadcom Kona PWM controller device tree bindings
This controller has 6 channels.
Required Properties :
-- compatible: should contain "brcm,kona-pwm"
+- compatible: should contain "brcm,kona-pwm" or "brcm,kona-pwm-v2"
Is v2 used on a newer generation of kona SoCs? On i.MX these variants
are usually named after the first SoC that came with the new variant. Is
this sensible here, too?
It doesn't make as much sense here as different revs of the IP block are
picked up based on various decisions.
A new SoC could decide to use an old version.