Web lists-archives.com

[PATCH 4.18 083/197] net: hns3: Fix for phy link issue when using marvell phy driver




4.18-stable review patch.  If anyone has any objections, please let me know.

------------------

From: Jian Shen <shenjian15@xxxxxxxxxx>

[ Upstream commit 60081dcc4fce385ade26d3145b2479789df0b7e5 ]

For marvell phy m88e1510, bit SUPPORTED_FIBRE of phydev->supported
is default on. Both phy_resume() and phy_suspend() will check the
SUPPORTED_FIBRE bit and write register of fibre page.

Currently in hns3 driver, the SUPPORTED_FIBRE bit will be cleared
after phy_connect_direct() finished. Because phy_resume() is called
in phy_connect_direct(), and phy_suspend() is called when disconnect
phy device, so the operation for fibre page register is not symmetrical.
It will cause phy link issue when reload hns3 driver.

This patch fixes it by disable the SUPPORTED_FIBRE before connecting
phy.

Fixes: 256727da7395 ("net: hns3: Add MDIO support to HNS3 Ethernet driver for hip08 SoC")
Signed-off-by: Jian Shen <shenjian15@xxxxxxxxxx>
Signed-off-by: Peng Li <lipeng321@xxxxxxxxxx>
Signed-off-by: Salil Mehta <salil.mehta@xxxxxxxxxx>
Signed-off-by: David S. Miller <davem@xxxxxxxxxxxxx>
Signed-off-by: Sasha Levin <alexander.levin@xxxxxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
 drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_mdio.c |    2 ++
 1 file changed, 2 insertions(+)

--- a/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_mdio.c
+++ b/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_mdio.c
@@ -208,6 +208,8 @@ int hclge_mac_start_phy(struct hclge_dev
 	if (!phydev)
 		return 0;
 
+	phydev->supported &= ~SUPPORTED_FIBRE;
+
 	ret = phy_connect_direct(netdev, phydev,
 				 hclge_mac_adjust_link,
 				 PHY_INTERFACE_MODE_SGMII);