Web lists-archives.com

Re: [PATCH v3 2/2] gpio: davinci: Do not assume continuous IRQ numbering






On 6/13/2018 1:36 AM, Grygorii Strashko wrote:


On 06/12/2018 02:59 AM, Keerthy wrote:
Currently the driver assumes that the interrupts are continuous
and does platform_get_irq only once and assumes the rest are continuous,
instead call platform_get_irq for all the interrupts and store them
in an array for later use.

Signed-off-by: Keerthy <j-keerthy@xxxxxx>
---

Tested for GPIO Interrupts on da850-lcdk board.

Changes in v3:

    * Changed irqs type from unsigned to int

Changes in v2:

    * Extended the logic of using saved IRQs to unbanked IRQs
      as per Grygorii's suggestion.

   drivers/gpio/gpio-davinci.c                | 54 +++++++++++++++++++-----------
   include/linux/platform_data/gpio-davinci.h |  3 +-
   2 files changed, 36 insertions(+), 21 deletions(-)


[...]

@@ -383,7 +396,7 @@ static int gpio_to_irq_unbanked(struct gpio_chip *chip, unsigned offset)
   	 * can provide direct-mapped IRQs to AINTC (up to 32 GPIOs).
   	 */
   	if (offset < d->gpio_unbanked)
-		return d->base_irq + offset;
+		return d->irqs[offset];

this one seems right

   	else
   		return -ENODEV;
   }
@@ -396,7 +409,7 @@ static int gpio_irq_type_unbanked(struct irq_data *data, unsigned trigger)
d = (struct davinci_gpio_controller *)irq_data_get_irq_handler_data(data);
   	g = (struct davinci_gpio_regs __iomem *)d->regs[0];
-	mask = __gpio_mask(data->irq - d->base_irq);
+	mask = __gpio_mask(data->irq - d->irqs[0]);

but this one is not. You can't do "base + offset" or "irq - base" ops
if Irqs range is not sequential. So, in my opinion, here you need to
convert irq to gpio bank offset (hwirq value in irq_data is not offset
- gic specific value) which means - walk through d->irqs[x] and find
item with d->irqs[x] == irq which will give gpio bank offset.
Than offset can be used to build mask.

Agreed.


if (trigger & ~(IRQ_TYPE_EDGE_FALLING | IRQ_TYPE_EDGE_RISING))
   		return -EINVAL;
@@ -458,7 +471,7 @@ static struct irq_chip *keystone_gpio_get_irq_chip(unsigned int irq)
    * (dm6446) can be set appropriately for GPIOV33 pins.
    */
-static int davinci_gpio_irq_setup(struct platform_device *pdev, int bank_irq)


[...]

   #include <asm-generic/gpio.h>
#define MAX_REGS_BANKS 5
+#define MAX_INT_PER_BANK 32
struct davinci_gpio_platform_data {
   	u32	ngpio;
@@ -41,7 +42,7 @@ struct davinci_gpio_controller {
   	spinlock_t		lock;
   	void __iomem		*regs[MAX_REGS_BANKS];
   	int			gpio_unbanked;
-	unsigned int		base_irq;
+	int			irqs[MAX_INT_PER_BANK];
   	unsigned int		base;
   };