Re: [PATCH] PCI: DPC: Clear AER status bits before disabling port containment
- Date: Wed, 16 May 2018 18:44:22 -0400
- From: Sinan Kaya <okaya@xxxxxxxxxxxxxx>
- Subject: Re: [PATCH] PCI: DPC: Clear AER status bits before disabling port containment
On 5/16/2018 5:33 PM, Alexandru Gagniuc wrote:
> AER status bits are sticky, and they survive system resets. Downstream
> devices are usually taken care of after re-enumerating the downstream
> busses, as the AER bits are cleared during probe().
> However, nothing clears the bits of the port which contained the
> error. These sticky bits may leave some BIOSes to think that something
> bad happened, and print ominous messages on next boot. To prevent this,
> tidy up the AER status bits before releasing containment.
> Signed-off-by: Alexandru Gagniuc <mr.nuke.me@xxxxxxxxx>
> drivers/pci/pcie/dpc.c | 4 ++++
> 1 file changed, 4 insertions(+)
> diff --git a/drivers/pci/pcie/dpc.c b/drivers/pci/pcie/dpc.c
> index 8c57d607e603..bf82d6936556 100644
> --- a/drivers/pci/pcie/dpc.c
> +++ b/drivers/pci/pcie/dpc.c
> @@ -112,6 +112,10 @@ static void dpc_work(struct work_struct *work)
> dpc->rp_pio_status = 0;
> + /* DPC event made a mess of our AER status bits. Clean them up. */
> + pci_cleanup_aer_error_status_regs(pdev);
> + /* TODO: Should we also use aer_print_error to log the event? */
> pci_write_config_word(pdev, cap + PCI_EXP_DPC_STATUS,
> PCI_EXP_DPC_STATUS_TRIGGER | PCI_EXP_DPC_STATUS_INTERRUPT);
I think Keith has a patch to fix this. It was under review at some point.
Qualcomm Datacenter Technologies, Inc. as an affiliate of Qualcomm Technologies, Inc.
Qualcomm Technologies, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project.