Re: Install on hp-pavilion-g6-2100 stops at 98%
- Date: Sun, 3 Sep 2017 15:08:37 +0200
- From: Luis Speciale <lspeciale@xxxxxxxxx>
- Subject: Re: Install on hp-pavilion-g6-2100 stops at 98%
Le 03/09/2017 à 14:48, Pascal Hambourg a écrit :
Le 03/09/2017 à 14:26, Luis Speciale a écrit :
Le 03/09/2017 à 14:00, Pascal Hambourg a écrit :
Le 03/09/2017 à 13:32, Luis Speciale a écrit :
ls gives me
Obviously hd0 is the internal disk. So hd1 must be the USB drive.
However ls should show partitions on it. I wonder if the image was
properly copied. Can you check the partition table on the USB drive ?
I don't see how I can do this. In my Mac, I get
The disk you inserted was not readable by this computer.
Never mind. I misread what you wrote and though that you got the error
when booting from the USB drive. Reading more carefully, I understand
that the installation process completed without error or freezing and
you are now rebooting from the internal drive.
indicates that the EFI firmware loaded GRUB from /EFI/boot, which
contains the fallback boot loader. However it should load GRUB from
/EFI/debian as specified in the EFI boot entry that should have been
created during the installation of GRUB. Both locations contain the same
GRUB executable if you replied yes to the question about installing a
copy of GRUB in the removable device path. Otherwise, EFI/boot may
contain an obsolete version of GRUB from a previous installation.
$prefix and $root indicate that this GRUB expects its files to be
located on partition 2, which should be the root partition. You wrote in
a previous message that this partition contained the system directories.
What is the output of
If there is a grub directory, what is the output of
When you told me that you thought my USB wasn't maybe ok, I did another
USB following this instructions this time
I'm now reinstalling the whole thing
In some minutes I could answer your question