Re: name of pkg contaning lsof and netstat
On 2018-05-24 02:41, Csaba Raduly wrote:
> On 5/23/18, FHDATA wrote:
>> what package(s) do i need to install to get lsof and netstat ?
> A search for lsof in the Cygwin package search:
> says that lsof is in the busybox package.
> A search for netstat
> returns no hits. You are probably out of luck with netstat:
A version of netstat is included with Windows:
$ /proc/cygdrive/c/Windows/System32/netstat -?
Displays protocol statistics and current TCP/IP network connections.
NETSTAT [-a] [-b] [-e] [-f] [-n] [-o] [-p proto] [-r] [-s] [-x] [-t] [interval]
-a Displays all connections and listening ports.
-b Displays the executable involved in creating each connection or
listening port. In some cases well-known executables host
multiple independent components, and in these cases the
sequence of components involved in creating the connection
or listening port is displayed. In this case the executable
name is in  at the bottom, on top is the component it called,
and so forth until TCP/IP was reached. Note that this option
can be time-consuming and will fail unless you have sufficient
-e Displays Ethernet statistics. This may be combined with the -s
-f Displays Fully Qualified Domain Names (FQDN) for foreign
-n Displays addresses and port numbers in numerical form.
-o Displays the owning process ID associated with each connection.
-p proto Shows connections for the protocol specified by proto; proto
may be any of: TCP, UDP, TCPv6, or UDPv6. If used with the -s
option to display per-protocol statistics, proto may be any of:
IP, IPv6, ICMP, ICMPv6, TCP, TCPv6, UDP, or UDPv6.
-q Displays all connections, listening ports, and bound
nonlistening TCP ports. Bound nonlistening ports may or may not
be associated with an active connection.
-r Displays the routing table.
-s Displays per-protocol statistics. By default, statistics are
shown for IP, IPv6, ICMP, ICMPv6, TCP, TCPv6, UDP, and UDPv6;
the -p option may be used to specify a subset of the default.
-t Displays the current connection offload state.
-x Displays NetworkDirect connections, listeners, and shared
-y Displays the TCP connection template for all connections.
Cannot be combined with the other options.
interval Redisplays selected statistics, pausing interval seconds
between each display. Press CTRL+C to stop redisplaying
statistics. If omitted, netstat will print the current
configuration information once.
Take care. Thanks, Brian Inglis, Calgary, Alberta, Canada
Problem reports: http://cygwin.com/problems.html
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple